Used to make a Transfer (thin plastic film) of a Print for Dècoupage Water-based Dries Quickly Dries Clear Also an Adhesive and Sealer Glossy Finish Clean Brushes with Water
This film is very thin and eliminates the need for many layers of MODGE PODGE. It is more flexible than paper and therefore can be sretched to fit onto curved surfaces such as ostrich eggs and plates etc.

INSTRUCTIONS FOR TRANSFER GLAZE

	Trim your print but leave enough space around your picture so that you can stick masking tape around the edges to keep picture in place while applying TRANSFER GLAZE.
	Place your print, face up, on wax paper and secure onto wax paper with masking tape. Apply 3-6 coats of TRANSFER GLAZE allowing each coat to dry well. Apply 3-6 coats of TRANSFER GLAZE allowing each coat to dry well. Apply each coat in opposite direction i.e. First coat horizontally, second coat vertically.
	When print is completely dry soak print in warm water for at least 20-30 minutes.
	Remove print from water and while print is still wet, start rolling paper off the back of the print with your finger.
	Work very gently until there is no trace of any paper, but be very careful not to stretch or tear the sensitive film.
	When print is dry follow instructions for MODGE PODGE.

TOP TIPS Never dip a wet or dirty brush or applicator into your bottle of TRANSFER GLAZE. This will contaminate the fluid. Pour some TRANSFER GLAZE into a saucer and work from the saucer. Do not pour left over TRANSFER GLAZE back into your bottle. You cannot use photographs to make transfers – use photocopies of your photographs. It is not advisable to try to speed up drying time by placing any dècoupage projects in the sun. Allow all coats to dry at normal room temperature. Use with our large range of local and imported DÉCOUPAGE PAPERS.

Step1	Step2	Step3